We may earn a referral commission from some links on this page. It doesn't change your price or our recommendations.
Thruster specs
ezDrive Streamline H: specs, price and the boats it fits
The Streamline H is ezDrive’s most compact stern thruster, built for wake and ski boats with crowded transoms: it stands 7 to 8 in tall and sits 16 in off the hull, tucked under the swim platform. It pushes 88 lb both ways on 12 V, enough to walk the stern into a slip or swing around for a fallen rider. ezDrive has sold it since 2018, and several wake-boat builders offer it from the factory.
ezDrive publishes no price; you ask for a quote, and it will send a free full-size mock-up to check the fit first. The kit holds the iBox, the rocker switch, the mounting hardware and a 225 A breaker that doubles as the shut-off. You add the battery cable, which must be at least 1/0 gauge, and ideally a battery of its own. See what else you buy.
It goes on through one 1.25 in hole in the transom, with no fiberglass work; the guide allows eight hours, and one Nautique G23 owner took about ten. The motor is sealed and needs no service. It runs up to ten minutes at a stretch, asking you to confirm after three. Warranty: two years once registered, for the first owner and only on the boat it was fitted to.
Fitting it yourself? The installer section has every spec, and the Yacht Thruster and ezDrive review sets this model against the rest of the ezDrive range.
Where this summary comes from (8 sources, read 13 October 2026)
- ezDrive products page (horizontal and vertical models)
- ezDrive installation page (one 1.25 in fitting, no fiberglass work)
- ezDrive history (developed from 2016, launched 2018)
- Planet Nautique, 2022 to 2023: a G23 owner fits his own ezDrive
- ezDrive specs page (dimensions, weights, 225 A breaker with quick shut-off)
- ezDrive FAQ (sealed motor, no service; above the hull bottom; two years, registered)
- ezDrive Streamline installation guide, 7-26-2022 (8 hours; 1/0 AWG minimum or the warranty is void)
- ezDrive warranty (two years pleasure, one commercial, not transferable)
Key facts
- DIY level 4 of 5 You fit it, electrician connects
- Thrust 88 lb 40 kgf, ezDrive's rating
- Boat length Not published See our sizing below
- Price No US price None is published, so there is no fitted cost to work out
- Fitted by a yard No total No price to build on
- Voltage 12 V As sold
- Mounts External Fixed mount, stern
- To fit it Haul-out The boat comes out of the water
- Run limit Up to 10 min Continuous
Every figure here is the maker’s or a dealer’s. No US price is published, so there is no fitted cost to estimate. The full spec sheet is further down.
How much of the install is yours
DIY levels
- Level 5: Owner install. No yard, no electrician.
- Level 4: You fit it, electrician connects. You mount and wire it; a marine electrician makes the final connections.
- Level 3: Split with the yard. The yard does the below-waterline part; you do the wiring.
- Level 2: Wiring prep only. The yard fits the unit and does the hull work; you do the wiring prep.
- Level 1: Yard job. A qualified professional does all of it.
You Yard Electrician. The bar is labor hours; a haul-out is a note.
How we rate DIYYou: 8 to 16 h Yard: none Electrician: 2 to 4 h Out of the water on its trailer, or hauled.
- Mount the thruster at the transom; fit the battery and control box; run the cables You 8 to 16 h Our estimate. ezDrive prints no time; one owner reported about 10 hours, and the range is widened for a first install. Source.
- Final connections at the battery and the motor, load test Electrician 2 to 4 h Our estimate. Nobody publishes a time for the final connections and test on their own.
Your part needs:Drilling at the transomHeavy battery cableCrimping big lugs
A qualified marine electrician should make the final connections and test them before first use. Hours are labor only.
Is it right for your boat?
Our figure is the longest boat one unit can steer in a 15 knot wind. It is a range because each kind of boat catches the wind differently. Here a sailboat gets full thrust to 37 ft, and an express cruiser to 48 ft.
The table below tries the ezDrive Streamline H on each kind of boat, at every length that kind of boat is built in. The wind is 15 knots and the rules are the finder’s own. A length counts as a fit when the unit gives the thrust that boat needs where it mounts. ezDrive publishes no boat length, so thrust alone decides.
| Boat | Full thrust at 15 knots | Still a fit, in lighter wind |
|---|---|---|
| Pontoon & tritoon | Not listed. Its maker does not name this kind of hull. | |
| Sailboat | 32 to 37 ft | 38 to 56 ftfull thrust to about 10 knots at 56 ft |
| Houseboat | Not listed. Its maker does not name this kind of hull. | |
| Catamaran | Not listed. An external unit bolts to the side of a single hull at the bow or to its transom, and a cat has two narrow hulls with a bridgedeck between them, so there is nowhere forward to hang one. | |
| Trawler | 31 to 37 ft | 38 to 55 ftfull thrust to about 10 knots at 55 ft |
| Motor yacht | 35 to 37 ft | 38 to 55 ftfull thrust to about 10 knots at 55 ft |
| Bass & flats | No length. More thrust than the boat needs. | |
| Wake & ski boats | No length. More thrust than the boat needs. | |
| Express cruiser | 40 to 48 ft | 49 to 65 ftfull thrust to about 11 knots at 65 ft |
| Center console | No length. More thrust than the boat needs. | |
Reading the two length columns. The first column is where one unit gives all the thrust the boat needs in 15 knots. The second is where the finder still lists it: the unit falls short of what the boat needs by no more than 10 percent, and gives the whole figure only in the lighter wind named. On a boat shorter than the first column’s shortest length, the unit is more than the boat needs.
It is sized for four kinds of boat here. For your own boat, the finder gives an answer that also counts your drive and who does the fitting. The compare page sets this unit beside others.
What it costs fitted
No US dollar price is published for the ezDrive Streamline H, so we build no total for it. The yard’s share of the job is on the cost page.
The sizing and the costs on this page are estimates, for guidance only and without warranty. They are no quote, and nobody has inspected your boat. Check them against the maker’s manual and your yard before you rely on them. Terms of use.
What else you buy
What follows comes from ezDrive’s Streamline installation guide and the FAQ, 26 July 2022, read 30 September 2026.
- In the box
- The thruster, the iBox, the rocker control, mounting hardware, nozzles and tools, and a 225 A push-to-trip breaker, which also serves as the quick shut-off.
- Bought separately
- The 1/0 AWG battery cable, sealant, a 5 A in-line fuse for the joystick or throttle option.
- Charging
- It wires straight to a 12 V battery, and ezDrive suggests a Group 31 AGM of its own. The guide says nothing about a charger.
The manual’s words, page 2: “A dedicated AGM battery is recommended to power your ezDrive thruster, however, it is not required for every installation.”
A yard job adds these parts on top of the unit: $8 to $12 for the priced ones below, at Fisheries Supply’s prices on 30 September 2026, plus the batteries, cable and charger.
| Part | What it is | What to ask for | Dealer price |
|---|---|---|---|
| Control-circuit fuse and switch | A small fuse, and often a switch, on the thin wire that powers the panel or control box. | A 5 A in-line fuse on the joystick or throttle feed | $8–$12Blue Sea in-line ATO fuse holders, at Fisheries Supply, read 16 October 2026. |
| Battery cable and lugs | The two heavy cables from the battery to the motor, sized to the length of the run. The wiring calculator sizes them. | 1/0 AWG minimum | In the electrical line |
| Battery bank | A cranking-type bank near the motor, sized by the maker's cold cranking amps. The battery calculator checks it. | ezDrive names none | In the electrical line |
| Charger or charge feed | How the thruster bank gets charged: a shore charger of its own, a DC-to-DC charger or charging relay from the boat's system, or a charger built into the unit. | ezDrive names none | $146–$305NOCO GEN5X2 shore charger, Victron Orion-Tr Smart DC-DC charger, Blue Sea ML-ACR charging relay, at Fisheries Supply. |
The cost page has the whole list with what every maker says about each part.
For the yard and the installer
The full spec sheet, grouped the way a yard reads it. Every figure is the maker’s or a dealer’s, with its source.
| Thrust and motor | |
|---|---|
| Thrust | 88 lb (40 kgf) As printed: 88lbs at 12v, 77lbs at 10v |
| Voltage | 12 V |
| Fitting | |
| Type | External, fixed mount |
| End of the boat | Stern |
| What it does to the hull | 1.25 in stainless steel threaded thru-hull fitting through the transom; position not stated relative to the waterline |
| Haul-out to fit it | Yes |
| Maker’s boat length | Not published |
| Price and ordering | |
| Price | No US price published |
| Part number | Not held for this listing |
| Documents | |
| Manual | Installation manual (PDF)on the maker's site |
| Warranty | ezDrive gives 2 years for pleasure use and 1 for commercial use. ezDrive's warranty page |
| The site’s review | Yacht Thruster and ezDrive review |
Draw, cable, fuse and battery, at each voltage
These are the maker’s own figures, at each voltage it is sold at. The cable is the size for the shortest run in the maker’s table. A longer run may need heavier cable, and the wiring calculator works that out for your own boat.
| Voltage | Draw | Maker’s cable | Fuse | Battery | Run limit |
|---|---|---|---|---|---|
| 12 V | 245 Anominal draw | At least 1/0 AWG, whatever the run; smaller cable voids the warranty, the maker saysStreamline installation guide, page 2 | 225 A breakerStreamline installation guide, parts list | Suggests Group 31 AGMezDrive FAQ | up to 10 min continuousFAQ |
- At 12 V: size the cable for your run, or check the battery you have.
What to weigh
Each point names the fact it rests on.
What to weigh
- The boat comes out of the water to fit it: it needs a 1.25 in stainless steel threaded thru-hull fitting through the transom; position not stated relative to the waterline.The mount goes through the hull, and the maker describes no fitting afloat
- ezDrive publishes no boat length for it. The boat table is our sizing alone.The maker's documents, as the database records them
- No US dollar price is published for it, so we can work out no fitted cost.The maker and the dealers the database reads
What the manual and listings say
This is the note we keep on the ezDrive Streamline H, written from the maker’s manual, its product pages and the dealer’s listing.
In the box: The kit has the iBox, a rocker control and a 225 A breaker. Battery cable is bought.
Our note
The most compact of ezDrive's three mounts: 7 to 8 in tall and 16 in out from the hull, 37 lb in aluminum or 40 lb in stainless. A 12 V transom unit for wake and ski boats, through one 1.25 in threaded fitting in the transom. ezDrive rates it 88 lb at 12 V and 77 lb at 10 V, and it draws 245 A.
It runs up to ten minutes, with a confirm-to-continue at three and a quarter minutes. ezDrive does not say whether it can be fitted afloat. No price is published. The maker quotes by email. A dedicated Group 31 AGM battery is recommended, not required.
Videos
Two of ezDrive’s own videos, from its YouTube channel: how the unit works, drawn, and a full install on a wake boat. They are the maker’s pitch. Watch them for what the unit looks like and how it goes in, and take any claim back to the figures above.
Other sizes and close alternatives
The same 88 lb unit, sold for other mounts:
- Upright, flat against the transom: ezDrive Standard.
- Upright, on a bracket off the transom: ezDrive Vertical Stand-Off.
These are ezDrive’s nearest sizes by thrust, in any of its lines.
- One size up: ezDrive PLUS, 136 lb.
These are other makers’ units of the same style, for the same end, within a quarter of its published thrust. Each is that maker’s nearest match.
- DockStar Smart Thruster, stern, 90 lb, $4,270 to $4,570.
- Sleipner SX35 Compact Stern, 93 lb, $3,870 to $4,167.
- Max Power CT45 stern pod, 99 lb, $3,275.
Every model with a page here is listed, maker by maker, on the thruster index.